Heya guys...
I just installed my Toucan Ractive Supersflow Cold Air Intake System. This thing didn't come with directions so i used my common knowledge of cars to install it the best way fit. I ended up taking out the whole old system and putting the filter behind the bumper. Sound right? now there were a few hoses that i had to unhook from the old one. One went to some kind of sensor and another went straight to the engine. And i also disconnected the old intake system from what i believe is the mass air flow sensor. What do i do about the hoses that go to the engine and the sesnor thing? And what do i do about the what i think is the mass air flow sensor? Thanks :)

Also if you need to pictures of what im talking about please please email me :D

I would think that the setup you purchased is not custom for your application. If it doesn't have the correct fittings for hoses, MAF, etc. you're SOL. Most likely the fittings would have to be welded on or look for an AEM or Injen that has them already in place.

question - why did you even touch it??[:@]

the only advice i give to customers that come to our garage is - to put everything back together if you dont want to start replacing your oxygen filters same often as oil.