auto to manual swap and now no start....
#1
auto to manual swap and now no start....
So I swapped my 1992 lx to a manual trans. I have not been able to get it to start as of yet, It will crank and get fuel but no spark. I have so far discovered it is throwing a code fifteen and twenty, I have replaced the main relay and tested the coil and ignition control module, both were good. I have also tried three different ecu and still no spark. I am at a loss with this, any help would be greatly appreciated. Also does any ne know how to by pass the neutral safety switch so i can disconnect the auto shifter and it will still crank?
Last edited by phantomgrey92; 05-30-2013 at 05:57 PM.
#4
Ok, it is one of those things that gets missed sometimes when this kind of work is done.
As you know the 15 is ignition output, I was hoping the ground would cure this. So we need to start testing the dist and the inputs/outputs.
Is the BLK/YEL hot when the key is to on/pos II?
As you know the 15 is ignition output, I was hoping the ground would cure this. So we need to start testing the dist and the inputs/outputs.
Is the BLK/YEL hot when the key is to on/pos II?
#5
OK I'll have to check that, I do know that the dizzy worked when pulled, the entire engine trans ecu and harness all came from a running driving car. I did notice something odd tho, there was a wire tapped into the blue wire going into the distributor that I removed during the swap any ideas?