is crankshaft hitting valves?
#21
Sorry, didn't realize you're all were still posting... Thanks. Will try to answer your suggestions in this post
1) the car is automatic so that shouldn't be the problem
2) I would love to be able to turn crankshaft/camshaft 22 to 30 degrees but it barely moves..
3) the pulley is brand new...that is what got me started on this project. It was bad - the outer part was slipping off the rubber from the inner part and was somewhat warped, I guess it did indeed rub against the cover and cut through it slightly.
I have some time tomorrow to look into it again. Don't know what the hell to look for, but wish me luck!
1) the car is automatic so that shouldn't be the problem
2) I would love to be able to turn crankshaft/camshaft 22 to 30 degrees but it barely moves..
3) the pulley is brand new...that is what got me started on this project. It was bad - the outer part was slipping off the rubber from the inner part and was somewhat warped, I guess it did indeed rub against the cover and cut through it slightly.
I have some time tomorrow to look into it again. Don't know what the hell to look for, but wish me luck!
Thread
Thread Starter
Forum
Replies
Last Post
yousef
General Tech Help
5
05-05-2009 10:06 AM