TPS Calibration using ohms
#1
TPS Calibration using ohms
So I know how to calibrate the tps using the voltage measurements from the TPS wires to the harness but I'm wondering if I can use ohms (resistance) that way I do not have to hook the TB up to the car in order to calibrate it.
#6
The initial calibration write up I used had voltages and was used when the tps was hooked up. I figured ohms would be easier since no power source is needed but wasnt sure if it was something that would vary from each car. I couldnt anything on hondas in particular.
But this is much easier, I could try the voltage approach using a usb cable and a connector to verify if I get bored.
But this is much easier, I could try the voltage approach using a usb cable and a connector to verify if I get bored.
#10
To determine which pins to measure resistance (or voltage) I would download the 94 shop manual. The common diy thread on top of the gen tech help forum has a link to online shop manuals.
If access is a pain, you can do the measurement at the proper ECU pins.
If access is a pain, you can do the measurement at the proper ECU pins.