No vehicles were vandalized, stolen, stripped, or harmed during the acquisition of these parts!!!!!!! I'm an honest seller & I believe highly in karma. Also the bible states to be fair/honest in all your dealings.
without further ado' I bring you JDMJNKY's k-series part out......
User id: jdmjnky/ jdm_jnky
Name: Joel
Location: 909 califas!
Contact: jdmjnky@yahoo.com
Aim: jdmjunke1
Form's of payment: Paypal (confirmed, & preferred), M.O.( postal money order), Bank CC (cashiers check), or cash on pick up!
With all the commotion in my life I just cant motivate myself to finish my k-series power plant. Nor the cash flow!!! I'll part out all this stuff for a grand total of 2,500 o.b.o. Open to suggestions. They have been divided into 6 packing crates. 5 crates are packed, w/ items, if I added each up it would definitely total over 2500, that's just the items inside. I'm also letting go the blocks also. I don't know street prices on all these items & it would take a while to get, but here's a generic marked down dealer price sheet on a fraction of the stuff I'm including for that 1 low price... I am willing to trade for sohc/ & specific b-series items
K20A2 parts:
Engine cover assy. (qty. x3) retail...$60
A/C compressor ...$413
A/C clutch set ...$150
A/C Bracket ...$50
Timing chain guides (both) ...$100
Intake cam (bare retail)...$300
Exh cam ...$300
Tensioner assy. ...$60
Chain case (qty. x2 individually priced) ...$80
Crank sensor (qty. 3) ...$60
Flywheel (qty. x2) ...$180
Oil dipstick (qty. x5) ...$8
Valve cover (qty. x2) ...$30
Coil cover ...$25
A3 Cylinder block assy. ...$1510
Half shaft assy ...$200
Tensioner ...$90
Side brkt ...$25
RR engine brkt. ...$50
Trans mount ...$40
Rubber assy mount ...$40
Stopper FR eng. ...$70
Exh. Gasket ...$10
Ignition coil (qty. 4) ...$70 ea
INT. man. tubing ...$40
Int. Manifold (qty. x3) ...$280
Fuel Pipe ...$60
Meter assy/ Gauge cluster ...$380
P/S pump (qty. x2) ...$400
Throttle body w/ sensors (bare retail) ...$650
BDL Throttle body ..$300
VTC solenoid ...$180
H20 Pump ...$100
Thermo housing (qty.x2) ...$30

So 2 blocks plus more parts then I have listed above for 2500 o.b.o
























K24 basically complete bottom end
[img]http://www.we-todd-did-racing.com/files/1035306_

 

nice. what project was this part of?

 

these are all OEM parts?

 

Looking at the packaging, I'd say some are and some aren't

 

my em1 rebuild but i called the motor uits, funds just aren't right!

 

yes they are minus the BDL TB....

 

[sm=repost.gif]|Time for this post to say GoodBye..

Bye, Bye

WheelBrokerAng